Security level: Low (Allow all connections).System port: 8080 (system service port).TCP/IP configuration: If port trunking is enabled (dual LAN models only), the port trunking mode will be reset to "Active Backup (Failover)".TCP/IP configuration: Disable Jumbo Frame.TCP/IP configuration: Obtain IP address settings automatically via DHCP.Once the NAS has been reset, the following takes place: The new password is the first MAC address (found on the NAS sticker under "MAC1").Re-connect to the NAS using your browser.Press and hold down on the reset button for approximately three seconds until a beep sounds. The first soft reset only clears the network settings and resets the admin password to the MAC address of the enclosure. There are two ways to use the reset button to change some settings on your QNAP NAS. The soft reset will only change your account and network settings while the hard reset will wipe all the drives, allowing you to start fresh much like Windows 11. There are actually five ways to reset your QNAP NAS running QTS 5.0, including soft and hard resets.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |